-
-
-
From Mats Selen
How to do a simple exploration of potential variation using a sheet of damp paper (no sound). -
From Mats Selen
If the breadboard holes are too tight to stick a component or a wire into then you can loosen them up using a pin on the "other" end of a wire with a clip. -
-
From Mats Selen
Finding the materials you need for the Lab 1 equipotential experiment: A non-conducting plate or other shallow container to hold water. Some small conductors to act as… -
From Mats Selen
How to measure voltage difference that are not produced by the IOLab device, but rather by something else (like a battery, or perhaps two points in a circuit). -
-
-
-
-
-
-
-
-
-