-
From Mats Selen
shows how to put a remote into pairing mode (no sound) -
From Mats Selen
Using the magnetometer to figure out the direction of the magnetic field produced by your little neodymium magnet. -
From Mats Selen
Moving a magnet up and down in a loop of wire induces an EMF in the wire -
From Mats Selen
Describes how the magnetometer calibration works -
From Mats Selen
Making A Loop of wire using the E&M kit clipped wires. (no sound) -
From Mats Selen
This video has no sound. It shows how to set the IOLabRootDir environment in Windows variable to have the IOLab-Workfiles folder created in a specified location rather… -
From Mats Selen
Shows how to take repository data of V1 and V2 and create a plot of V1-V2 using Excel. -
From Mats Selen
Sharing Data with the Repository -
From Mats Selen
Zooming and Panning and Analyzing -
From Mats Selen
Recording and Recalling Data -
From Mats Selen
Getting & Running the IOLab Software -
From Mats Selen
Shows how to measure the time between bounces even when they happen very quickly. -
From Mats Selen
Recording the light intensity from an LED light-bulb -
From Mats Selen
Recorded sound made by open D guitar string -
From Mats Selen
Brightness and Voltage of Red LED (DAC set to 3.3V) -
From Mats Selen
Brightness and Voltage of Green LED (DAC set to 3.3V) -
From Mats Selen
The IOLab light sensor is sensitive to infrared light that your eve cant see. -
From Mats Selen
Measure LED Brightness -
From Mats Selen
Lighting the LEDs in the E&M Accessory Pack -
From Mats Selen
Using the D6 Output to Create a Voltage -
From Mats Selen
Lab 1 Practice & Preparation -
From Mats Selen
How to do a simple exploration of potential variation using a sheet of damp paper (no sound). -
From Mats Selen
If the breadboard holes are too tight to stick a component or a wire into then you can loosen them up using a pin on the "other" end of a wire with a clip. -
From Mats Selen
How to re-pair a remote that has been unpaired from its dongle (no sound) -
From Mats Selen
Lab 1: Zoom and Share DAC to A7 data. -
From Mats Selen
How to measure voltage difference that are not produced by the IOLab device, but rather by something else (like a battery, or perhaps two points in a circuit). -
From Mats Selen
Using the DAC (June 2020) -
From Mats Selen
Measuring Voltages (June 2020) -
From Mats Selen
EM kit polarizers description -
From Mats Selen
EM kit magnet with hook description