-
shows how to put a remote into pairing mode (no sound)
Pairing Mode
-
Using the magnetometer to figure out the direction of the magnetic field produced by your little neodymium magnet.
Neodymium Magnet Field Direction
-
Moving a magnet up and down in a loop of wire induces an EMF in the wire
Moving Magnet Induces EMF
-
Describes how the magnetometer calibration works
Magnetometer Calibration
-
Making A Loop of wire using the E&M kit clipped wires. (no sound)
Making A Loop (no sound)
-
This video has no sound. It shows how to set the IOLabRootDir environment in Windows variable to have the IOLab-Workfiles folder created in a specified location rather…
IOLabRootDir
-
Shows how to take repository data of V1 and V2 and create a plot of V1-V2 using Excel.
Finding V1 - V2
-
Sharing Data with the Repository
Sharing Data Using the Repository
-
Zooming and Panning and Analyzing
Zooming and Panning and Analyzing
-
Recording and Recalling Data
Recording and Recalling Data
-
Getting & Running the IOLab Software
Getting & Running the IOLab Software
-
Shows how to measure the time between bounces even when they happen very quickly.
Bouncing Pen
-
Recording the light intensity from an LED light-bulb
LED Lightbulb
-
Recorded sound made by open D guitar string
Guitar D String
-
Brightness and Voltage of Red LED (DAC set to 3.3V)
Brightness and Voltage of Red LED
-
Brightness and Voltage of Green LED (DAC set to 3.3V)
Brightness and Voltage of Green LED
-
The IOLab light sensor is sensitive to infrared light that your eve cant see.
IR sensitivity
-
Measure LED Brightness
Measure LED Brightness
-
Lighting the LEDs in the E&M Accessory Pack
Light up your LEDs
-
Using the D6 Output to Create a Voltage
Using the D6 Output to Create a Voltage
-
Lab 1 Practice & Preparation
Lab 1 Practice & Preparation
-
How to do a simple exploration of potential variation using a sheet of damp paper (no sound).
Electric potential variation on damp paper (no…
-
If the breadboard holes are too tight to stick a component or a wire into then you can loosen them up using a pin on the "other" end of a wire with a clip.
Loosening Up Breadboard
-
How to re-pair a remote that has been unpaired from its dongle (no sound)
Pairing a Dongle and Remote (no sound)
-
Lab 1: Zoom and Share DAC to A7 data.
Lab 1: Zoom and Share DAC to A7 data (no sound)
-
How to measure voltage difference that are not produced by the IOLab device, but rather by something else (like a battery, or perhaps two points in a circuit).
Measuring External Voltages
-
Using the DAC (June 2020)
Using the DAC to Produce Voltages
-
Measuring Voltages (June 2020)
Measuring Voltages Produced by IOLab
-
EM kit polarizers description
EM kit polarizers
-
EM kit magnet with hook description
EM kit magnet with hook
Search for ""